Time Electronics Handheld Loop Simulator and Source (Loop-Mate 1), 4 to 20 mA

The 7006 is a single function low-cost pocket sized simulator, designed for test and calibration of process loops. It is simple operation and engineers will be able to pick up the unit and get to work immediately. Just select 4 to 20 mA or 10 V loop, and TxSim, RxTest, or 0 to 10 V DC simulation mode. Internal loop drive supply for powering the loop is also available if required.

As a simulator it acts as a source to provide the loop signals 4 to 20 mA or 0 to 10 V. No complicated selection of the output, just operate up/down buttons to increase or decrease the signal. There are 7 set-points, 0%, 10%, 25%, 50%, 75%, 90%, 100%. Each is indicated on a high brightness LED and an audible beep sounds as you step between them. Auto-stepping mode (adjustable rate) allows the 7006 to be left connected stepping up and down.

For loop signal checking the 7007 Loop-Mate 2 is a dedicated indicator, just as easy to operate and designed for use with the 7006. Select the loop type, 4 to 20 mA, or 0 to 10 V, and whether you want the display in direct units, or % of span. The LCD display shows the signal to an accuracy of 0.05 % either in mA, V, or % of span. Both units are powered by a single standard PP3 battery that gives up to 40 hours continuous use.

Features

• 4 to 20 mA or 0 to 10 V loops
• 7 calibration set-points
• Accuracy 0.1 %
• TxSim and RxTest modes
• Autostep output - adjustable rate
• Battery powered PP3
• Internal loop drive supply
• Use with model 7007 LoopMate 2 indicator